Skip to content
/SLASHPLAY

How to set the min rate on an L4D2 server

Add sv_minrate 10000 to left4dead2/cfg/server.cfg; players with a lower rate setting are raised to it.

sv_minrate

The lowest data rate, in bytes per second, the server lets a player use. 5000 by default.

sv_minrate <bytes>

Examples

sv_minrate 10000

Raise the floor to 10000.

Arguments

bytesRequired
Bytes per second, or 0 for no minimum.

What it does

Raising it keeps players with a very low rate setting from getting choppy updates.

Good to know

  • Typed in the Console tab it lasts until the server restarts. To keep it, add sv_minrate 10000 to left4dead2/cfg/server.cfg, which the server runs at every map load.

Run it on your server

On a SLASHPLAY server, type it in the Console tab of the server page; the reply shows right under it. A value set there lasts until the server restarts. To keep it, add the line to left4dead2/cfg/server.cfg. New to this? Start a L4D2 server first.

Your own
L4D2 server.

From $0.03 an hour, only while it runs. New accounts get 6 free tokens.