How to set sv_pure in Day of Defeat: Source
Type sv_pure 2 in the Console tab, then changelevel dod_avalanche; the new mode applies from that map.
sv_pure
Controls which custom files players may use, from -1 (no rules) to 2 (only the game's own files).
sv_pure <-1|0|1|2> Examples
sv_pure 2 Only the game's own files from the next map.
sv_pure Prints the help and the current mode.
Arguments
-1|0|1|2Required- -1 no rules, 0 rules in cfg/pure_server_minimal.txt, 1 cfg/pure_server_full.txt then cfg/pure_server_whitelist.txt, 2 cfg/pure_server_full.txt.
What it does
Run it without a value to print the modes and the current one; a fresh server prints Current sv_pure value is 0. A new value applies from the next map.
Good to know
- The server prints the current mode and the rules for each value when you type
sv_purealone. - A change applies when the next map loads: follow it with
changelevel.
Run it on your server
On a SLASHPLAY server, type it in the Console tab of the server page; the reply shows right under it. A value set there lasts until the server restarts. To keep it, add the line to dod/cfg/server.cfg. New to this? Start a DoD:S server first.
Your own
DoD:S server.
From $0.03 an hour, only while it runs. New accounts get 6 free tokens.