Skip to content
/SLASHPLAY

How to make observers wait for the map in Sven Co-op

With observer mode on, type mp_observer_cyclic 1 in the Console tab of your server page. Players then observe until the map lets them respawn.

mp_observer_cyclic

With observer mode on: 0 players observe until a spawn point is free, 1 until the map lets them respawn.

mp_observer_cyclic <0|1>

Examples

mp_observer_cyclic 1

Wait for the map to allow respawning.

Values

ValueWhat it does
0Default Observe until a respawn point is available
1 Observe until the map lets players respawn

Arguments

0|1Required
1 turns it on, 0 turns it off.

What it does

It only does anything when mp_observer_mode is 1.

Good to know

  • Sven Co-op's default_map_settings.cfg sets it to 0 when each map loads, and a map's own .cfg can set its own value. On SLASHPLAY, type it in the Console tab to change it for the current map.

Run it on your server

Type it in the Console tab of the server page; the reply shows right under it. A value set there lasts until the server restarts. To keep it, add the line to svencoop/server.cfg in the Files tab: Sven Co-op runs it at every map change. New to this? Start a Sven Co-op server first.

Your own
Sven Co-op server.

From $0.03 an hour, only while it runs. New accounts get 6 free tokens.