Skip to content
/SLASHPLAY

How to set single spawn point mode in Sven Co-op

Type mp_multiplespawn 0 in the Console tab of your server page for a map with one spawn point. Players then spawn up to 92 units apart.

mp_multiplespawn

Uses all of a map's spawn points. Set 0 only for a map with a single spawn point. Default 1.

mp_multiplespawn <0|1>

Examples

mp_multiplespawn 0

For a map with one spawn point.

Arguments

0|1Required
1 turns it on, 0 turns it off.

What it does

With 0 players spawn up to 92 units from the spawn point so they don't get stuck in each other.

Good to know

  • Sven Co-op's default_map_settings.cfg sets it to 1 when each map loads, and a map's own .cfg can set its own value. On SLASHPLAY, type it in the Console tab to change it for the current map.

Run it on your server

Type it in the Console tab of the server page; the reply shows right under it. A value set there lasts until the server restarts. To keep it, add the line to svencoop/server.cfg in the Files tab: Sven Co-op runs it at every map change. New to this? Start a Sven Co-op server first.

Your own
Sven Co-op server.

From $0.03 an hour, only while it runs. New accounts get 6 free tokens.